Wall position check
Marking the correct height and anchor points before any drilling
Farwaniya
Wall-hung basin in Firdous
Wall-hung basin installation in Firdous usually starts in a family home wanting an extra wash point in the kitchen or second bathroom. We set convenient height for daily use, drill the wall carefully to avoid existing pipes, fix the bracket securely and organize hot, cold supply and waste efficiently.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Firdous houses are relatively modern and built to a standard design, most with concrete walls and pipes running in from outside. You typically find vertical supply lines behind kitchen and bathroom walls, which means we must trace them precisely with a detector. Waste can either connect to an existing pipe under the bathroom floor or run internally along the wall to the majlis floor trap.
Firdous sits in Farwaniya governorate near the Sixth Ring Road, a modern residential district with uniform design.
Before completion we fill the basin and let water run to check every joint and measure supply pressure from existing mains pipes.
What the installation covers
Bracket installation
Fitting wall brackets rated to carry the basin weight safely
Supply line connection
Connecting hot and cold lines with new isolation valves fitted
Trap and waste fitting
Setting a new trap and connecting to the waste run at the right fall
Mixer and fittings
Fitting the mixer, strainer and all trim with sealed connections
Pre-handover test
Pressure check, waste flow test and full leak inspection before leaving
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Wall-hung basin
Other services in Firdous
Western toilet
See the detailsAblution basin
See the detailsBathtub installation
See the detailsJacuzzi installation
See the detailsCommon questions
Questions about Wall-hung basin in Firdous
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do we connect the basin to existing supply pipes without cutting too much wall?
We use a detector to pinpoint the vertical pipe routes precisely then open a narrow aperture at a clear junction point. We shift the pipes slightly if needed and use sliding couplings to connect the hot and cold supply lines.
What if the basin waste outlet is far from existing drain pipes?
We run a new waste pipe along the interior wall or under the floor, depending on the house layout. We choose a route maintaining steady fall and not clashing with other pipes or services, then test flow before sealing.
