Crack welding
direct thermal weld along each fracture line in the tank wall

Capital
Water tank welding in Mirqab repairs cracks and leaks in plastic and fibreglass tanks above shops and commercial centres near the Central Market. We identify the tank type and fracture precisely, then choose welding that keeps the wall flexible. The tank is filled and inspected under real working pressure from daily flow.
Shops and stores in Mirqab near the Grand Mosque mostly rely on medium-sized tanks bolted directly to roofs or mounted above upper floors. These tanks endure daily pressure swings from constant filling and emptying. When examining the crack, we check the tank's alignment on its support brackets, because a tilted tank will fail the weld again if side pressure persists. We jack the tank slightly to fix the angle before welding starts.
Mirqab is a commercial district in Kuwait city near the Central Market and Grand Mosque, where commercial density is very high.
A small vent hole is drilled at the tank top before welding to allow air escape and prevent voids in the joint.
direct thermal weld along each fracture line in the tank wall
re-welding inlet and outlet fittings where the flange joint has failed
resin-and-mat layer over the damaged zone before the final weld seal
internal camera after welding reveals any weak point before refilling
replacing the tank lid when the leak source is the cover seal
written record of weld locations and camera inspection result
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
We open the bottom drain valve and let the tank empty for hours until fully dry inside. Then we inspect the bottom carefully and weld from outside if possible, or from inside using a temporary external brace.
Proper welding leaves no odour if we use approved material matched to the tank type. We fill the tank after welding and let it run through for two hours before human use.
