Tank installation
Mounting the tank on a level concrete base to protect its base from cracking
Farwaniya
Roof tank installation in Khitan Al-Jadida
Roof tank installation in Khitan Al-Jadida starts with checking roof structure and load limits. We position the tank and set it on concrete base, run supply from the meter and overflow to the stand pipe, then pressure-test each joint before completion.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most Khitan Al-Jadida houses are simple residential buildings with flat, accessible roofs. The tank usually goes in a corner away from air-con units and aerials. We measure from the main meter beside the building and choose the shortest rising pipe route, because every extra metre loses pressure. We check that overflow drains away from the walls and does not puddle on the roof.
Khitan Al-Jadida lies in Farwaniya governorate, a small residential suburb of orderly family homes where roof tank installation is a standard practice.
The full tank is tested by monitoring pressure at every connection point for five minutes to confirm there is no weeping.
What the installation covers
Inlet and supply lines
Running the fill line and distribution line to floors in PPR pipe
Overflow and drain line
Installing the overflow at correct slope so no water pools on the roof
Pump connection
Connecting the existing transfer or pressure pump and setting its switch
Float valve fitting
Fitting a brass float valve sized to the tank for accurate fill cut-off
Pressure test
Testing all joints under pressure before handover to confirm no leaks
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Roof tank installation
Other services in Khitan Al-Jadida
Underground tank construction
See the detailsAcoustic leak listening
See the detailsApartment first-fix
See the detailsBasement sump pump
See the detailsCommon questions
Questions about Roof tank installation in Khitan Al-Jadida
Need someone now? The emergency line is open any hour.
+965 9668 4964
How high must the tank be to give enough pressure for the flat?
We need at least two-and-a-half metres height from the tank bottom to the highest tap in the building. We measure from the top floor drain and position the tank to give this difference, or water will dribble at the upper bathroom shower.
What if the building roof is too tight for a large tank?
We choose a narrower tank of suitable volume or split the load between two smaller tanks side by side. We ensure the concrete base under each tank is thick enough to spread the weight across the roof.
