Hot and cold supply points
PPR lines routed precisely to basin, shower and toilet positions
Ahmadi
Bathroom first-fix in Ahmadi Stables
Bathroom rough-in at Ahmadi Stables starts by understanding the spread-out buildings and long distances between them. We run hot and cold supply from the central tank through buried pipes to every fixture point. Waste drains downslope toward distributed floor traps across the site. We test pressure and flow before walls close.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Equestrian facilities at Ahmadi Stables are spread across long distances with sandy ground and wide surface drainage patterns. Bathroom rough-in here requires careful fall calculation over the long run to keep water moving without pooling. We use larger-diameter pipes for distance and position every trap at a low point. Floor traps must sit away from feed storage and grain areas. Leaks from hot and cold supply in sandy soil show up fast, so we pressure-test hard before burial.
Ahmadi Stables sits in Ahmadi governorate, a dedicated equestrian and racing zone that demands reliable rough-in built to handle heavy use.
Because buildings are spread far apart, we pressure-test each section of the rough-in separately before connecting them together.
What the rough-in covers
Bathroom waste lines
uPVC drain runs laid at correct fall to prevent standing water
Floor trap installation
Floor trap levels set before screed to align flush with final tiling
Vent connection
Connecting the waste run to the vent stack prevents trap siphoning and odour
Pressure test
Documented pressure test on supply lines before walls are permanently closed
Point positions record
All supply and waste point locations recorded for finishing and future maintenance
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Bathroom first-fix
Other services in Ahmadi Stables
First-fix plumbing and electrics
See the detailsKitchen first-fix
See the detailsApartment first-fix
See the detailsDrainage first-fix
See the detailsCommon questions
Questions about Bathroom first-fix in Ahmadi Stables
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do we ensure enough fall over such long distances?
We calculate total fall from the fixture to the floor trap and switch to larger pipe where gradient reduces. We raise pipe supports at intervals to maintain steady descent throughout.
Does sandy soil affect how we test the pipes?
Yes, we use higher test pressure because sandy ground does not stop water seepage quickly. Any small leak will show on the surface very fast.
