Tank installation
Mounting the tank on a level concrete base to protect its base from cracking
Ahmadi
Roof tank installation in Shuaiba Industrial
Roof tank installation at Shuaiba Industrial starts with checking roof strength and position near the main pipe exit. We choose a spot that lets water fall naturally into the lower network. We connect inlet and outlet, run a full pressure test, and hand over.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Industrial plants across Shuaiba need roof tanks to hold water at low pressure, which steadies supply to machinery. Concrete roofs on industrial buildings are strong enough for a heavy tank, but pipe runs to production equipment stretch long distances. We check each line length and fall, then set tank height so it gives the pressure needed at the furthest use point without overloading the tank.
Shuaiba Industrial sits in Ahmadi governorate, a cluster of petrochemical plants and stations that rely on steady water supply.
Before final installation, every weld and connector is tested at pressure higher than operating pressure to check for leaks under real load.
What the installation covers
Inlet and supply lines
Running the fill line and distribution line to floors in PPR pipe
Overflow and drain line
Installing the overflow at correct slope so no water pools on the roof
Pump connection
Connecting the existing transfer or pressure pump and setting its switch
Float valve fitting
Fitting a brass float valve sized to the tank for accurate fill cut-off
Pressure test
Testing all joints under pressure before handover to confirm no leaks
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Roof tank installation
Other services in Shuaiba Industrial
Underground tank construction
See the detailsAcoustic leak listening
See the detailsApartment first-fix
See the detailsBasement sump pump
See the detailsCommon questions
Questions about Roof tank installation in Shuaiba Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do we decide tank height when pipes run far from roof to production equipment?
We calculate the total height difference from roof to the furthest use point, then set tank height to give enough pressure without major loss. We test pressure at every end point before handover.
Can we install a second tank on a separate roof section if demand is very high?
Yes, for very high demand we connect two tanks with a balance pipe so they fill together and keep pressure even. We test flow balance and total pressure after all connections.
