Pit inspection
Pit dimensions and condition checked before any pump is selected
What the work covers
Pit condition, pump sizing, float switch, discharge line and final run test under load
Pump selection
Capacity matched to actual water ingress rate, not a generic size
Float switch setup
Switch level set and float travel confirmed free inside the pit
Discharge line
Discharge direction verified and non-return valve fitted to stop backflow
Electrical connection
Earthing and moisture-rated socket confirmed before the pump is powered
Load test
Pit filled manually and full run cycle confirmed before handover
How the job runs
Call or WhatsApp
Describe whether the pump is dead, cycling badly or the pit is flooded
Site inspection
We inspect the pit, existing pump and discharge line on arrival
Diagnosis and quote
Root cause identified and price confirmed before any work begins
Installation or repair
Pump fitted or fault corrected, non-return valve and float set correctly
Test and handover
Full load test run in your presence before we leave the site
Mistakes that make the pump fail you
No non-return valve fitted
Water drains back into the pit each time the pump stops, burning it out early
Float touching the pit wall
A stuck float never triggers the pump and the pit overflows without warning
Undersized pump chosen
A low-capacity pump runs continuously yet cannot keep pace with incoming water
Wrong electrical socket used
A standard socket in a damp pit corrodes or trips before the first flood event
Before you call: what to check first
Power socket condition
Confirm the nearby socket is live and the circuit breaker has not tripped
Float switch movement
Lift the float by hand if reachable and check whether the pump starts immediately
Water level in the pit
Note whether water is rising steadily or standing still to help size the replacement
Age of the current pump
Knowing the install date helps us decide between repair and full replacement quickly
More in water pump install and service
Roof-tank pump
See the details
Hot-water circulation pump
See the details
Pump pressure-switch repair
See the details
Cesspit pump
See the details
Sewage pump
See the detailsPart of Water pump install and service · All services · Back to the home page
What decides the price
No fixed rate applies because each job differs across these factors
Repair versus replacement
Replacing only the float or switch costs less than a full pump swap
Pump size and capacity
A high-flow submersible costs more than a small-pit utility pump
Basement access
A confined or flooded pit increases labour time and overall cost
Discharge pipework
New or rerouted discharge pipework adds materials and labour to the quote
Call-out timing
Night and public-holiday call-outs are priced differently from scheduled visits
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Sanitary fixture installation
- Cistern and mixer repair
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Water pipe leak repair
Restaurants
- Restaurant gas lines
- Gas leak detection
- Kitchen plumbing runs
- Water pump install and service
Complexes and buildings
- Building and complex maintenance
- Roof tank and basement pumps
- Water tank installation
- Operation and maintenance contracts
Why us
Why Al Amana for basement sump pump
Amana means trust. Someone else’s home is not ours to be careless in.
Photographed before and after
Do not take our word for it. Look at the work yourself.
We find it before we break it
The leak is marked before a single tile comes up.
24-hour emergency
A leak does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
We cover all of Kuwait
Six governorates, 139 areas.
CapitalHawalliFarwaniyaAhmadiMubarak Al-KabeerJahra
Common questions
Questions about basement sump pump
Need someone now? The emergency line is open any hour.
+965 9668 4964
The sump pump runs without stopping but the pit never empties. what is wrong?
The three common causes are an undersized pump that cannot match the inflow rate, a missing non-return valve that lets water drain back each time the pump stops, and an unaddressed water source. We diagnose the cause before recommending a replacement.
Can replacing just the float switch fix the problem instead of changing the whole pump?
Yes, if the motor and impeller are in good condition a float or switch replacement is enough. We check the motor first so you are not paying to fix one part of a pump that is already failing.
Do you service sump pumps in residential towers and commercial buildings, not only private villas?
Yes. We cover private homes, apartment buildings, residential complexes and commercial properties across all 6 governorates of Kuwait.
What is the real risk of leaving a failed sump pump for a few days?
Standing water in the pit seeps into walls and foundations, creating persistent damp that weakens the structure and encourages mould. The longer it is left, the greater the secondary damage costs.
Is it worth installing two pumps in the same sump pit?
A backup pump makes sense in high-inflow sites or commercial basements where a failure is costly. For most residential pits, a single correctly sized pump with a reliable float switch is sufficient.
